Last updated on July 5th, 2024 at 12:57 pm
This post may contain affiliate links. If a product or service is purchased using a link(s) in the post below a small commission may be earned.
Last updated on July 5th, 2024 at 12:57 pm
Sponsored Content
This is a very nice and large drying rack. I was able to review it for Todeco on behalf tomoson.comΒ being that i had been looking for a drying rack I jumped at the chance to apply for this promo. I was able to purchase the rack at a discounted price.Β
When it arrived it came in this large box.Β
It isnβt very heavy but it is large. And once I opened the large box I was greeted by another box which held the contents of the drying rack.Β
So as you can see it has a number of parts. It has a total of 6 hanger frames, 6 fixed folder knobs, 4 fame tubes, 2 clothes hanger arms, 1, Foot support tube, 4 foot stand supports, 2 caster foldable feet and a bag or screws and nuts. Also a multi-language instruction pamphlet.
The instructions leave a lot to be desired. They are a bit on the vague side.Β
They are easy to read but still donβt explain everything. I figured out things on my own while following the diagrams. I will admit this it did take me about an hour or more to set the rack up fully.Β
setting up the racks was what took me the longest. once you place them together with the plastic fixing knobs you have to align the screws in the appropriate holes and add the nuts at the end. Letβs just say you need a lot of patience to get this part done. The rest of the assembly process is pretty simple.Β
Once the hanger frames are done. I moved to the foot support. This is basic insert the rob into the caster feet arms and then add the support arms. This is another tricky set up because you need to align the screw with the holes and add a nut at the end.Β
For this you need two long screws for the bottom rod support and 4 short screws for the pole supports the screws also require a nut for each attachment. Β
With that done I inserted the pole into the slot and attached the first set of hanger frames. All you do is loosen the plastic fitting knob and slide it down to the desired place. to set it into place you just tighten the knobs. (The gray blob in the lower right hand corner is my cat Pal who happened to the shot.)
Once that was done I installed the second pole and slide the other racks over the top.Β
The hanger arms snap into place on the pole thanks to the hook design.Β
All in all this is a very nice laundry drying rack once you get it all set up. This would make a great addition to anyoneβs laundry room if you have the space for it. Β For more info please visit the link below:
http://www.amazon.com/dp/B00MA2WHRA?m=A2VUPBBWEMEF5Z&ref_=v_sp_widget_detail_page
I will post a video outline more about it soon.